![]() I used inserts to mount my Beast 16n's so I had to thread the holes with a 5/16-18 bottom tap. IMPORTANT: Remember to start with the small plastic pice that should be mounted under neat the front part of the toe binding. If yo choose to use the screws that came with your Dynafit Beast 16n's then just put some good long cure (24 hour) epoxy glue in the holes and mount your bindings. Use a sharp knife then use a vacuum cleaner to get all the dust out of the holes. I used a drill press just because I have one :0)Ĭlean up the holes. Make sure to use a drill that suits your skis and the screws you chose to use (For the original Dynafit screws use a 4mm drill bit and drill 9.5mm deep) you can use a slightly larger drill 4.2-4.5mm if your skis has metal layer near the top sheet). then use a drill press or Drill Guide to drill the holes to the desired depth (I used 6.5mm drill to a 9.5mm depth for my Binding Freedom inserts). Use a awl or a nail to make drill guide holes in the skis at the drill marks. Tape the Dynafit Beast 16 drill template to the skis and make sure the center lines and boot center lines line up with the marks you previously made on your skis. Mark out the ski boot center (Or your preferred boot center) on both skis, also make a ski center line with a marker. Instructions of how to alter the template to fit the boot size is printed on the template printouts. Now assemble the two parts of the template with tape. Print the Dynafit Beast 16 template in two samples (Both parts x 2) and make sure that you print it at 100% then double check with a ruler at the 100mm marks that the print was printed in the correct scale. (Even if you don’t have A4 paper.) After printing, double check the dimensions with a ruler.ĭownload this The templates are designed for A4 paper (not 8.5 x 11), so choose the A4 setting on your printer. R ide 10 Binding (ATK RT 2.0) Mounting Template and Instructions.R ide 10 Binding (ATK RT 2.0) User's Guide, Maintenance and Warnings.Core 12 Binding User's Guide and Warnings.Core 12 Binding Mounting Template and Instructions.Z01, Z02 & Z02 Junior ski brake installation (or swapping).Z01, Z02 & Z02 Junior Mounting Template (Note: Use the Jr markings for the Z02 Junior Extra Small (XS) and the Small markings for the Z02 Junior Small.).We also offer Jigarex and any tools you could need for traditional mounts as well. The original inserts for skis, made in america and the best option for getting the most out of your skis and bindings. 1 Mark Three-Pin line as per ski manufacturer's recommendation. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. Archives
March 2023
Categories |